2006-2011 Camry Aurion · Service Manual STEERING

INSPECTION

Inspection · Vehicles built from Jun 2006


INSPECT TIE ROD ASSEMBLY LH

  1. C132329
    Secure the tie rod assembly LH in a vise.

  1. Install the nut to the stud bolt.

  1. Flip the ball joint back and forth 5 times or more.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

    Torque:
    Turning torque:
    0.98 to 3.92 N*m{ 10 to 40 kgf*cm , 8.7 to 34.7 in.*lbf }

    If turning torque is not within the specified range, replace the tie rod assembly LH.


INSPECT TIE ROD ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.


INSPECT TOTAL PRELOAD
  1. Temporarily install the 2 steering rack ends to the power steering rack.

    NOTICE:
    Do not fully turn the power steering rack without the steering rack ends as it may damage the oil seal in the rack housing.

  1. C148628E01
    Using SST, fully turn the power steering rack right and left 10 times to settle it.
    SST
    09616-00011  

  1. C148629E01
    Using SST, turn the control valve and measure the preload.
    SST
    09616-00011  

    Torque:
    Standard preload (turning):
    1.6 N*m{ 16 kgf*cm , 14 in.*lbf } or less

    If the preload exceeds the specified value, replace the rack and pinion power steering gear assembly.

  1. Remove the 2 steering rack ends from the power steering rack.

← DISASSEMBLY (from Jun 2006)REASSEMBLY (Jun 2006 – Sep 2006) →